Facet International is the world leader in jet fuel handling, industrial coalescer separators, bilge water separator and other separation technology. Advanced filtration and separation products and systems for aviation, marine, petrochemical, water tretment, power genreation and general industrial markets.

 
 | 
 | 
 | 
 | 
 | 
A member of the Purolator Advanced Filtration Group  
 
 

 

  GNG Series Go-No-Go® Military Monitor Cartridges (2" OD, outside to inside flow)


FOR MAXIMUM WATER ABSORPTION, SOLIDS HOLDING CAPACITY AND SHUTDOWN PROTECTION TO ASSURE CLEAN,
DRY FUEL

The Facet 2" (51 mm.) nominal outside diameter GNG Series Go-No-Go® monitor cartridges perform three jobs—they absorb free and emulsified water to less than 2 ppm; remove ultra-fine solids; and shut down system flow when hit with a localized slug of water, giving you clean, dry fuel. The GNG Series Go-No-Go® monitor cartridges are designed to flow from the outside to inside at a rate of 1 gallon (3.79 liters) per inch of length.

Go-No-Go® monitor cartridges meet the latest edition of Military Specification (MIL-M-81380C(AS) for Monitor, Contamination, Aviation Fuel Dispensing Systems.

The presence of water or solids in the incoming fuel will be indicated by an increase in the pressure differential or a decrease in the flow rate as the cartridges reach their maximum capacity for solids, water or a combination of both. When either happens, the cartridges should be replaced.

Each GNG Series Go-No-Go® monitor cartridge is constructed of various water absorbent media, plus fine filtration layers wrapped around a molded center tube for balanced flow and structural strength—all encased in a protective outer sock material. The end cap material is of injection molded, glass-filled nylon which provides superior strength and ease of maintenance. This material gives excellent support for the o-ring on the mounting/adaptor end.


• Tested and qualified to meet the latest edition of Military Specification (MIL-M-81380C(AS) for
   Monitor, Contamination, Aviation Fuel Dispensing Systems
• New conductive end caps with anti-static properties which greatly reduce the possibility of
   static discharge during the fueling process
• Multi-layered media for increased solids holding, water removal and shutdown protection
• Structurally withstands a minimum of 150 psid
• Less than 0.3 mg/liter of solids in effluent
• Less than 2 ppm of water in effluent
• Buna-N gaskets—Viton available on request
• Not adversely affected by exposure to temperatures varying from -65°F to 160°F

Top