Facet International is the world leader in jet fuel handling, industrial coalescer separators, bilge water separator and other separation technology. Advanced filtration and separation products and systems for aviation, marine, petrochemical, water tretment, power genreation and general industrial markets.

Facet HP Series single-stage water coalescers,
commonly referred to as repack or hay pack housings, are horizontal, cylindrically shaped housings designed to protect filtration systems from gross amounts of water and solid contaminants.

Facet recommends using their wafer style repack coalescers since they allow the first two sections to be replaced when required. The third and successive sections require fewer changeouts since they may
remain relatively free of solids.

Coalescing first starts as the product enters the vessel. Due to the substantially reduced velocity, free water will fall out by gravity. While the product progresses through the mass packed media, further
coalescing occurs by impingement of water droplets on the media. At the same time, solids tend to fall out as the liquid enters the housing at a reduced velocity, but are further removed by filtration as the flow continues through the mass media.

All Facet HP Series single-stage water coalescer housings are built to ASME Code, Section VIII, with
many standard and optional accessories available to facilitate individual installation requirements.
Facet HP Series single-stage coalescers use wafer repacks to remove gross amounts of water and solids from fuel. They are available in several standard sizes to accommodate flows from 10 to 2000 gpm (38 to 7570 lpm). They provide protection to filtration systems from gross amounts of water and solids that are commonly carried through inbound transport pipelines.

HP Series housings offer an option of using coalescer cartridges for more efficient solids separation and liquid-liquid water separation. Use of an adaptor kit permits returning to the use of repacks at any time.

HP Series housings have no internal moving parts and are designed for easy servicing, thereby reducing maintenance costs. Each housing is manufactured with quality workmanship and materials to give long-lasting and dependable service.

• Body: Carbon steel construction
• ASME Code, Section VIII, Div. 1, stamped and certified
• Designed for 150 psi (10.5 kg/cm2) @ 250°F
• Housing Closure: Blind cover on housings less than 14" (356 mm) OD;
   Swing bolt closure on housings 14" (356 mm) OD and larger
• Housing Covers: Removable on housing up to 14" (356 mm) OD;
   Hinged on housings 14" (356 mm) thru 36" (914 mm) OD;
   Rotating davits on housings 42" (1067 mm) OD and larger
• Head Gasket: Buna-N — other material available by request
• Exterior: Prime coated
• Saddle supports for pier mounting

• Steel stands available • Internal epoxy coating